AEM V3 Water/Methanol Injection Kit, 35 PSI Standard Controller, 1.15 Gallon Reservoir
Racing Use Only, Not Legal for Road Use
AEM's V3 water/methanol injection kit for boosted gas engines running up to 35 psi. The boost dependent controller has an on-board MAP sensor with a molded-in nipple for the boost hose, so there is no external sensor to wire. Water/methanol injection lowers inlet air temperature and suppresses detonation, which gives you room to run more boost and timing. This kit comes with the 1.15 gallon reservoir.
Features
- Boost dependent controller with internal MAP sensor, 35 psi max
- Large adjustment knobs for the start and full activation points, covered status LED and test button
- Boost Safe failsafe output triggers on a short, loss of continuity, high or low voltage or low fluid. Use it to flash a warning light, pull boost or timing, or switch fuel maps on a standalone ECU
- Terminated harness with positive lock connector, color coded wires, integrated pump ground circuit and an extra wire for an optional on/off flow solenoid
- Machined billet injector with integral check valve to prevent unintended flow
- Three interchangeable injector nozzles: 250, 500 and 1,000 cc/min
- Recirculation style pump with integral fittings for quiet operation
- Reservoir with built-in conductive low fluid level sensor
- LED dash light for system status and low fluid warning
- Integrated fuse and molded mounting tabs on the controller
Specifications
| Part number | 30-3300 |
| Controller | Boost dependent, internal MAP sensor |
| Maximum boost | 35 psi |
| Reservoir | 1.15 gallon with low fluid level sensor |
| Nozzles | 250, 500 and 1,000 cc/min |
| Injection tubing | 20 ft. high pressure nylon |
| Fitment | Universal |
| Warranty | AEM 1 year |
What's Included
- Boost dependent controller and wiring harness
- Water/methanol pump
- 1.15 gallon reservoir with fluid level sensor
- Billet injector with three nozzles
- LED dash light
- 20 ft. of injection tubing
AEM recommends running the inline filter (30-3003) on every water/methanol system. The optional solenoid (30-3326) adds protection against unintended flow when the pump and tank sit higher than the nozzle.