AEM V3 Water/Methanol Injection Kit, Multi-Input Controller, 1.15 Gallon Reservoir
Racing Use Only, Not Legal for Road Use
AEM's V3 water/methanol kit with the Multi-Input controller, for high compression naturally aspirated engines and for boosted engines running more pressure than the standard controller's internal sensor can read. Instead of an on-board MAP sensor, the Multi-Input controller takes its signal from an external 0 to 5 V MAP sensor, a frequency based or 0 to 5 V MAF, or a frequency based injector duty cycle signal. This kit comes with the 1.15 gallon reservoir and a single injector.
Features
- Multi-Input controller: external 0 to 5 V MAP, frequency or voltage MAF, or injector duty cycle
- Works on naturally aspirated engines through the MAF or duty cycle settings, and on high boost engines above 35 psi with an external MAP sensor
- Boost Safe failsafe output for a warning light, pulling boost or timing, or switching fuel maps on a standalone ECU
- Terminated harness with positive lock connector, integrated pump ground circuit and an extra wire for an optional on/off flow solenoid
- Machined billet injector with integral check valve to prevent unintended flow
- Interchangeable 250, 500 and 1,000 cc/min nozzles
- Recirculation style pump with integral fittings for quiet operation
- Reservoir with conductive low fluid level sensor
- LED dash light for system status and low fluid warning
Specifications
| Part number | 30-3350 |
| Controller | Multi-Input (0 to 5 V, MAF frequency or voltage, duty cycle, external MAP) |
| Reservoir | 1.15 gallon with low fluid level sensor |
| Injectors | 1 |
| Injection tubing | 20 ft. high pressure nylon |
| Warranty | AEM 1 year |
The external MAP or MAF sensor is not part of this kit. AEM recommends running the inline filter (30-3003) on every water/methanol system. The optional solenoid (30-3326) adds protection against unintended flow when the pump and tank sit higher than the nozzle.